HM-1018 Build

[Greg K]

I bonded a stud to the body and mounted a bracket to the outer fender panels.

[rbranst69]

LASIK progress

[rbranst69]

Man not even have to repaint

[rbranst69]

I bonded a stud to the body and mounted a bracket to the outer fender panels.

Whose bonded studs do you use ? I would like to do that on my vents !

[Greg K]

I also used bonded studs for my vents too. Studs are weld mount brand. 1/4-20 x 1" SS studs with their 8040 adhesive.
Stud part # 142016 pack of 10
Adhesive part # 804030 ounce size if you can find it.

[rbranst69]

Test fit... looks good!!

[rbranst69]

Rhino lining the fenders and trunk. Gallon goes for miles !!

[Redstang69]

You're really moving along. Looking really nice.

[rbranst69]

Quickjacks from Csxparts.com. Wipacs installed, just neeed to wire them in.
Remaining : fuel sender, trunk light, wipers

[Greg K]

Looks like the Metro rubber will work well for you too.

[rbranst69]

Greg - thanks so much for that recommendation, that was perfect.   How did you come across that?

[Greg K]

When I was sourcing the front grommets for the quick jacks, I noticed them on their site. I also noticed since then there has been a couple others who have used them here too. I also picked up the latch pads and windshield trim pads too. Old catalog attached with old pricing.

[rbranst69]

The Wipac's came with Lucas bullet style male connectors, are the females something easily obtained locally at an auto parts store? The car side is a gm weatherproof connector, trying to decide which side to cut.

[Greg K]

Cut the bullets off and use a weatherpack connector or H4 style male connector. Also check the wiring to the headlight, been known to be wrong in some instances.
See my post here: https://forum.hurricane-motorsports.com/forum/index.php?topic=2695.0

[rbranst69]

Thanks again Greg!