home at last

[8milebaker]

more

[8milebaker]

I made this might have it anodize black or clear

[8milebaker]

redid this  and you can see the header i fixed

[8milebaker]

I was going with the cans ,but went stock just moved them to the fire wall .The breaks are blead and boy did they bleed got it stopped and the clutch works and release's radiator is in ......

[LMH]

Nice work! I like the fabbed valve covers too.
Larry

[danc30]

Your making great progress.

[8milebaker]

I was thinking that if I should have to pull the header after iam done, it would be alot of work soIam make this removeable so all I have to do is un bolt and drop out the bottem.

[8milebaker]

cut

[8milebaker]

alot of room

[8milebaker]

ready to bolt back I will drill and tap 10-32 cap screw along the 1x1.

[berzerko]

Looking great I see you have the inner fender liners in did you have to flatten the 90 bend that goes torward the outside of the car?
did you need to trim around the shocktowers
 In my application (very wide motor) I needed to flatten them  I like the idea of cutting it in half if I need to access the pipes

[8milebaker]

I didn't flattin the 90 , I cut around the tower because they rubbed,the pass. side the pipes will  come out with no mods.

[Tom]

Okay.  School me.  Is that NOT a GM HEI cap on the front of your engine?

[jwd]

Okay.

[8milebaker]

You can"t work on the car and man the grill,ran out of gas and pulled the backup out,the wife put the dogs on and went off doing what they do in the house...