woundering if HM kit provides roll bar bezels? forgot to ask Mr. Arps.
nice cobra jewelery on finishline, and cobra valley parts, looks like they tend more to spf any suggestions on other related shop
sites? late at night for me thought cobra venom kills you not keep you up all night, only antidote is to keep searching.
anyway i think my first post wore out its welcome got guys there going rounds on bb and sb funny wounder what a 4cyl would do
my son has an 06 GTI darn things fast 0-60 vw says 6.7 sec. i say 5.2 gee willikers had it 140 twice let me tell yous vw says limited at 130, speedo 180
for only 21K. read somwhere that some guys wanted to have secondary rides when not in their snakes this little Golf might replace my fx 45
anyway off subject but we are in the future and smaller is better computers, survailance gti's heck medical tech son of agun list goes on original things are great truly iam antiuqe hound but i love modern science as well. so ill be typn, later
once again and will always repeat thankyou for all of your time and responses this going to be real fun.
from eric. ;)
Bezels are not supplied. They're 1.5" dia.
Unfortunately, the rear bar needs an oval bezel and I haven't found anyone that makes them for 1 1/2" roll bars. They would be simple to make out of 1/8" aluminum. That's probably what I'll end up doing.
Jim
you're talken about the angle of rear down third member if you will,didnt notice on finish line, checking sites later
just gettn' what i think needs to be had. ya know i want my ompa lumpa and i want it now.
lol iam silly.
anyway thanks for info.hey any celebs on site? even all cant have real authentics.
eric :o
Eric,
I had Russ from Russ's Garage make my gromet..bezels. He custom builds each set $55.00 per set of three (3) with the oval shape for the rear support bar. He now builds them for the 1.5" size on your Hurricane.
Call him at 1 (510) 234-7376 or at 1066 McLaughlin St. Richmond CA. 84805
He builds a lot of thigs for Factory five Cobras and does very good work.
Check him out! Bill ;D
I noticed on SPF's, the rollbar brace is about the same position as on the Hurricane. (models before the brace angle was changed) I'm going to change my rollbar brace to the more accurate position but for the older Hurricanes, a grommet from SPF might fit. It would be black rubber and you might have to get an SPF owner to buy it as I don't know if they sell parts to everyone.
Larry
Hi Eric,
I emailed Mike re. groumets for 1081 a couple of weeks ago and he said they now supply a rubber groumet with the roll bars. Confirm with him re. your car.
If you want to stir up the snake's nest here and else where, put a warmed over twin turbo Toyota Supra motor in your car, you can smoke 'em plenty good with that. We tried to put one in my old beater replica but it was too wide. Should fit just nice in yours. People forget the 2 liter in line 6 heritage of our cars.
Gotta have fun....
Ken